facebook
Othonos 39, 17343
Agios Dimitrios Athens
Mon-Fri
08:30 - 16:30
+30 2109966555
+30 2109969444

Multi Switch

Multi Switch (1:1 16A)

Transfer Systems

The Riello UPS Multi Switch is a high availability and versatile intelligent switch that provides redundant power to connected equipment with two AC input sources. The Riello UPS Multi Switch supplies power to the connected loads from a primary mains source. If that primary source becomes unavailable, the Riello UPS Multi Switch automatically transfers loads to the secondary source. The transfer time from one source according the ITI (CBEMA) chart does not impact the operation of the connected equipment as the switching occurs safely between the two input sources regardless of any phase differences. The Riello UPS Multi Switch monitors the current and provides warnings when power consumption draws near the maximum rating which helps prevent downtime to the equipment. Riello UPS Multi Switch has 8 independent IEC 10 A outlets allowing several devices can be plugged directly into the Rack without the need for an additional Rack PDU. The units have a connectivity slot which allows for LAN connection and remote management through PowerShield3 software, Web interface, SNMP, or SSH which makes the Riello UPS Multi Switch an ideal device for the IT manager who needs flexibility and protection for their IT equipment. Multi Switch provides installations with power supply continuity. Its operating principle ensures higher reliability than a single UPS, (with or without its own internal bypass).

Features

Technical Specifications

Product Brochure

Main features:

Protection against load faults
If one of the loads fails (e.g. short circuit), Multi Switch disconnects the group of sockets where the load is connected, thus preventing other loads from being switched off (i.e. in the event of poor discrimination of the protection devices).

 Features

  • Full protection for loads against mains and load failures
  • Redundant power supply
  • Versatile to use: Multi Switch can be powered with 2 different power supplies (including 2 UPS of different sizes/types)
  • 19” cabinet installation
  • LCD Display panel
  • Can be connected to PowerNetGuard supervision software
  • No signal connection between the Multi Switch and the power sources or loadsis necessary
  • Slot for communications boards: the optional network card allows for remote in network connectivity, and management through HTTP, SNMP, and SSH protocol.

MODELSMSW
NOMINAL CURRENT16A

INPUT

Nominal voltage – sources S1/S2230 VAC single-phase + N
Input voltage tolerance180-276 VAC (selectable)
Switched input phasesPh + N (two poles)
Nominal frequency50/60 Hz
Input sockets2 x IEC 320 (16 A)

OPERATION SPECIFICATIONS

Transfer type“Break Before Make”
Tranfer time following source failure< 8msec (S1/S2 synchronised) 20 msec (S1/S2 non synchronised)
OUTPUT 
Nominal voltagechoice of one of the two input power sources
Max.load for each output4 A
Output sockets8 x IEC 320 10 A

ENVIRONMENTAL SPECIFICATIONS

Efficiency at full load> 99%
Noise at 1 m from front (from 0 to full load)< 35 dBA
Operating temperature0 °C – 40 °C
Relative humidity90% non-condensing
Max. installation height1000 m at nominal power (-1% power for every 100 m above 1000 m) – Max 4000 m
Reference standardEN 62310-1 (safety) EN 62310-2 (electro-magnetic compatibility)

INFO FOR INSTALLATION

Weight (kg)10
Dimensions (WxDxH) (mm)19” x 360mm x 2U
ColourRAL 5004
IP ratingIP 20
CommunicationsRS232 / Slot for communication interface

MultiSwitch

            Download the Pdf here

CALL US
CONTACT US